Description
SFP Module
The Helmholz SFP transceiver modules are intended for use in Helmholz FLEXtra switches, but can also be used in other switches with a compatible SFP port. The modules support an Ethernet transmission rate of 1 Gbit/s. The SFP transceiver modules should always be installed in pairs with a technically suitable fiber optic cable. They are approved as Laser Class 1 in accordance with IEC 60825-1. Please observe the relevant safety regulations for the use of laser products.
It is very easy to install an SFP module in a free SFP port of your switch. To do this, fold down the safety clip and remove the dummy plug. Insert the LC connector into the SFP module and fold the bracket back up. The module is now mechanically locked in the SPF port and you can put the switch into operation. SFP modules may be plugged and unplugged during operation. Please note, however, that plugging or unplugging during operation can disrupt the communication of the system. Further information can be found in the manual.
Design
- Singlemode Fiber up to 10km
- Singlemode Fiber up to 40km
- Multimode Fiber up to 500m
- Multimode Fiber up to 2km
Features
- SFP (“Small form factor Pluggable”) Modul
- Duplex LC-Port
- Singlemode (700-997-xxx) or Multimode fiber (700-998-xxx)
- Data rate 1,25 Gbit/s, NRZ
- Single 3,3V Power Supply
- Compatible with SFF-8472 Digital Diagnostic Monitoring Interface
- Compatible with IEEE-802.3z Gigabit Ethernet
